Bore Tech’s C₄ Carbon Remover™ is a cutting-edge carbon cleaner that quickly and effectively removes heavy carbon fouling without the hazards, toxicity, and odors typically found in competitive cleaners.

C₄ CARBON REMOVER IS 100%

Bore Tech C₄ Carbon Remover features a highly advanced chemical formulation that begins its assault on carbon fouling by utilizing a strategic blend of chemical surfactants that quickly loosens and releases carbon deposits from the surface.

C₄ Carbon Remover’s proprietary formulation utilizes a sophisticated blend of surfactants, penetrants, suspending agents, and chemical action to remove stubborn carbon deposits. This enhanced formulation provides a deep clean and also effectively neutralizes and removes the corrosive residues found in surplus ammunition and black powder.

The C₄ Carbon Remover is the ideal cleaner for barrels, throats and chambers, AR bolt and bolt carriers, flash suppressors, compensators, revolver cylinders, gas pistons, and any other place extreme carbon fouling is found.

Are your firearms Bore Tech C₄ Carbon Remover clean?

Bore Tech – Redefining Gun Care
Proudly made in the USA

C₄ CARBON REMOVER

100% Barrel Safe
Odor Free
Non-Hazardous
100 % Biodegradable
Contains No Ammonia
Non-Flammable

Please see our convenient and easy to use Chemical Selection Guide by clicking the below image or going to the Knowledge Center.

Chemical Selection Guide

Bore Tech C₄ Carbon Remover™ Use Instructions

UNLOAD FIREARM

1) Wet 3 to 4 Bore Tech X Count patches with C₄ Carbon Remover and individually push through bore to remove loose fouling. Only push patches through the bore in ONE direction.

2) Next, make 10 to 15 passes with a tight fitting Bore Tech brush saturated with C₄ Carbon Remover.

3) Then repeat Step 1 and let C₄ Carbon Remover soak for 5 to 10 minutes. For badly fouled rifles or parts, extended soak times may be needed.
FOR EXTENDED SOAKING PERIODS PLEASE TEST SMALL AREA TO ENSURE COATING/FINISH COMPATABILITY

4) Finally, push dry patches through the bore until they come out clean.

5) Repeat above steps if necessary.

6) Before storing firearm, dampen a patch with C₄ Carbon Remover and push through bore. This will protect against rust/corrosion for up to 2 weeks under normal storage conditions.

7) For extended storage or in adverse conditions apply Bore Tech Friction Guard XP Gun Oil.

8) Before using firearm, always run a dry patch through the bore. This will remove any residue and ensure against obstructions.